Table of Contents
Advertisement
FS150
MAINTENANCE CHECK LIST
Before beginning servicing on any
FS150 unit, DISCONNECT FROM
AIR SUPPLY SOURCE
Check all fasteners and re-tighten,
•
since the machine will vibrate the
fasteners loose if they are not secured.
Use locktight.
•
Clean drum housing regularly to prevent
material buildup.
Inspect drum, and shafts for damage
•
and replace as needed.
•
Regularly lubricate grinder with a
suitable pneumatic motor lubricating oil.
Preferably one that incorporates a rust
inhibitor.
Check hose and fittings regularly for
•
wear or leaks, replace if necessary.
•
Check all fasteners and re-tighten,
since the machine will vibrate the
fasteners loose if they are not secured.
Use locktight.
6
SMITH Manufacturing
SAFETY GUIDELINES
• Accessories must be rated for at least the
speed recommended on the tool warning label.
Wheels and other accessories running over
rated speed can fly apart and cause injury.
• Hold tool by insulated gripping surfaces when
performing an operation where the cutting tool
may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed
metal parts of the tool "live" and shock the
operator.
• NEVER use tool with wood cutting blades or
other sawblades. Such blades when used on
a polisher frequently kick and cause loss of
control leading to personal injury.
• Hold the tool firmly and keeps hands away from
rotating parts.
• Make sure the abrasive disc or wool bonnet is
not contacting the workpiece before the switch
is turned on.
• When sanding metal surfaces, watch out for
flying sparks. Hold the tool so that sparks fly
away from you and other persons or flammable
materials.
• Do not leave the tool running. Operate the tool
only when hand-held.
• Do not touch the workpiece immediately after
operation; it may be extremely hot and could
burn your skin.
• Check that the workpiece is properly supported.
• Pay attention that the wheel continues to rotate
after the tool is switched off. Check hose and
fittings regularly for wear, replace if necessary
• This tool has not been waterproofed, so do not
use water on the workpiece surface.
• Ventilate your work area adequately when you
perform sanding operations.
• Use of this tool to sand some products, paints
and wood could expose user to dust containing
hazardous substances. Use appropriate respi-
ratory protection.
1-954-941-9744
www.SmithMfg.com
-ELECTRIC-
VERSION 5/2014
Advertisement
Table of Contents
