Call Settings - Nokia N-Gage Extended User Manual

Call settings

Note: To change the settings for call diverting, go
to Menu→ Tools→ Call divert. See 'Settings for call
diverting', p. 20.
Send my caller ID
• This network service allows you to set your phone
number to be displayed (Yes) or hidden (No) from the
person to whom you are calling. Or, the value may be
set by your network operator or service provider when
you make a subscription (Set by
Call waiting: (network service)
• The network will notify you of a new incoming call
while you have a call in progress. Select:
request the network to activate call waiting,
request the network to deactivate call waiting, or
Check status, to check if the function is active or not.
Automatic redial
• When this setting is activated, your game deck will
make a maximum of ten attempts to connect the call
after an unsuccessful call attempt. Press
stop automatic redialling.
Summary after call
• Activate this setting if you want the game deck to
briefly display the duration and cost of the last call. To
show costs, the Call cost limit
your SIM card. See p. 22.
40
Speed dialling
• Select On
dialling keys (
and holding the key. See also 'Assigning speed dialling
keys', p. 54.
Anykey answer
• Select On, and you can answer an incoming call by
briefly pressing any key, except
.
Voice message indicators:
shown if you have one or several voice messages.
network).
Line in use
• This setting is shown only if the SIM card supports two
subscriber numbers, that is, two phone lines. Select
Activate to which phone line
Cancel to making calls and sending text messages. Calls on both
lines can be answered irrespective of the selected line.
Note: You will not be able to make calls if you
select
service.
To prevent line selection, select
to
supported by your SIM card. To change this setting, you
need the PIN2 code.
Tip: To switch between the phone lines, press and
hold
needs to be activated for
and the numbers assigned to the speed
- ), can be dialled by pressing
, , and
, , or is
(network service)
(Line 1 or Line 2) you want to use for
Line 2 and have not subscribed to this network
Line change→ Disable
in standby mode.
if