Vacuum Components; Technical Specifications - Shark Rotator SV1107 Owner's Manual

ASSEMBLY
C
A
E
F
D
G
H
I

VACUUM COMPONENTS

A Main Body
B Handle
C Screw
D Dust Cup
E Dust Cup Release
F Upper Dust Cup Door Release
G Lower Dust Cup Door Release
H Motorized Brush
I
Power Button
J Charging Adapter
K Charging Base

TECHNICAL SPECIFICATIONS:

Volts: 14.4
4 TOLL FREE: 1-800-798-7398
B
d
J
K
fig. 1
ASSEMBLY
1 Insert the vacuum body into the
motorized brush. (fig. 1a)
2 Insert the handle pole into the top
of the main body. (fig. 1b)
3 Use a screwdriver to secure the
handle assembly in place with the
bolt (taped to the handle during
shipping). (fig. 1c)
4 Ensure that the dust cup is
securely in place. (fig. 1d)
CHARGING
1 The charge adapter plug will fit
into the charging base only one
way. Insert the charging adapter
plug by aligning the arrow on the
plug with the arrow next to the
charging jack on the back of the
charging base. (fig. 2)
2 Place the vacuum on the charging
base to charge. Charge the unit
for 6 hours before using the
vacuum for the first time. (fig. 3)
b
c
Charging
a
Charge
Complete
fig. 4
3 This unit is equipped with a
4 One half of the blue LED light
fig. 2
fig. 3
precision charger that monitors
the batteries to ensure a full
charge for every use and to extend
the life of the batteries. Depending
on usage, the time for a full
charge is 3 to 6 hours.
around the power button will
illuminate while the unit is
charging. When the charge is
complete, the complete oval will
be illuminated for one (1)hour.
(fig. 4) After one (1) hour, the LED
light will turn off but the unit will
remain fully charged.
If the charging light does not
illuminate, ensure that the
charging adapter is plugged
in properly to the wall outlet
and to the back of the charging
base. Also ensure that the
unit is properly seated in the
charging base.