Using Your Vacuum; Above Floor Cleaning - Shark BU1000 Series Owner's Manual

USING YOUR VACUUM

CONTROLS AND CLEANING MODES
POWER
Press the button on the UI Screen to
turn on power. To turn off power, press
the button again. To toggle between ECO,
FLOOR DETECT and BOOST modes, press
the mode selection button.
46
sh a rkclea n.e u
UPRIGHT
When upright, the nozzle will lock to allow
for free standing storage when the hand vac
is detached. Place your foot on the nozzle to
disengage the lock to begin floor cleaning.
ABOVE-FLOOR CLEANING
ABOVE-FLOOR WITH HAND VACUUM
Detach the hand vacuum to clean above-
floor areas. Press the front latch release
button on the hand vac where it meets the
wand, then lift off the hand vacuum. To
attach an accessory to the hand vacuum,
slide it into the opening in the nozzle. To
remove, press the front latch release button
on the hand vac where it meets the wand,
and slide out the accessory.
NOTE: All accessories are compatible with both the wand and the hand vacuum.
ABOVE-FLOOR WITH WAND
To detach the floor nozzle from the wand,
step on the nozzle while pressing the
nozzle release button at the bottom of
the wand. Lift the wand to remove it. To
reattach the wand, align it over the neck
of the floor nozzle, then slide it on until it
clicks into place.
s ha rkc lea n.eu
47