Fitting the bevel gear
•
Assembling the angle gear on the shaft. Turn the shaft so
that the splines on the drive axle mate in the angle gear.
•
First tighten the screw H and then the screw M.
M
H
Assembling the guard.
•
Remove the four screws C and the two screws F from the
bracket A.
F
A
C
•
Place the rubber sleeve D on the shaft E. The rubber
sleeve should sit between the arrow markings on the
shaft.
D
E
•
Place the bracket A around the rubber sleeve and fit the
screws F loosely.
F
A
A
8 –
English
ASSEMBLY
•
Guide the guard B onto the shaft so that the hole in the
guard aligns with the hole in the bracket. Tighten the
screws C.
B
4 x C
•
Align the bracket with guard so that it sits straight in
relation to the tines.
•
Tighten the screws F.