Onkyo TX-SA806 Service Manual page 155

DEBUG MODE-7
HDMI TROUBLESHOOT(1/3)
HDMI VIDEO SETUP TROUBLE
This trouble shooting map focuses on the video setup errors regarding HDMI.
For reference, read TX-SR806 Owner's Manual.
Analysis written below is of typical cases. So, more detailed check may
need in actual cases.
No picture
"Resolution Picture is OK
Display HDMI Error" is if player is
DEBUG MODE displayed connected
on FL directly to TV
Resolution or
Check aspect of TV EDID error
Information and player is between TV
on FL different from and player
each other
Change Change player's Change
settings of TV, resolution or TX-SR806's
player or aspect to TV's HDMI resolution
TX-SR806 capability to Through(1)
Note:
(1) Refer to Setup Menu 7-5. HDMI Setting
Resolution: Through.
(2) Refer to Setup Menu 7-5. HDMI Setting
x.v.Color: Disable.
No picture
"No HDCP Push
when HDCP-
support" is DISPLAY
capable DVD
displayed button for
or BD disc is
on FL 3 sec.
played
Player is not
HDCP-capable Displays
TV is not
or has special
"Unknown"
HDCP-capable
HDCP authentic on FL
procedure
Change player
Use Component
or consult with Authentic
Video instead
the player error
of HDMI
maker
Example:
Use Component
Samsung
Video instead
DVD-HR737
of HDMI
Video trouble
"No signal" is
HDMI cable is Only 1080p is
displayed
NG or too long not displayed
on FL
Change to
TV does not
short HDMI Player is PC
support 1080p
cable
The resolution Change
No signal from is not resolution setting
player supported by of player to
HDMI 1080i or less
Check player's Change Change
setting and PC setting to TX-SR806's
HDMI cable HDMI supported HDMI resolution
connection resolution to Through(1)
Bad picture
Picture is dark Bad aspect Bad color
Re-calibrate Set manually
Set TX-SR806's
video the aspect
x.v.Color setting
processor IC setting of
to disable (2)
in TX-SR806 player
TX-SR806/SA806
Picture is not
right
Confirm and
change
the TV setup
to match
the player
Confirm and
change
the player
setup to
match the TV