Cisco AT&T 3G MicroCell Getting Started Manual page 5

Option B
AT&T 3G MicroCell™
Note: If you normally use a USB cable to connect to your modem and computer, refer to 'Connect Your Devices with USB Cables?'
on page 8 of the
Remove the sticker that covers the rear panel of your 3G MicroCell.
To ensure success, it is important to complete the steps below in order.
1. Disconnect your current
on the 3G MicroCell.
2. Take the yellow Ethernet cable
labeled `Ethernet' on the 3G MicroCell and the other end to the
3. First, turn o power
equipment in the following order:
a) Modem
b) 3G MicroCell ( Do this last
the 3G MicroCell and connect the other end to an
High Speed Internet with Modem Attached to Computer
1
2
3
AT&T 3G MicroCell™ User Manual
Ethernet cable from the modem
that came with the 3G MicroCell and connect one end to the yellow
to your current internet equipment.
– connect one end of the
Ethernet Cable
(Included)
Power
Connect AC power adapter
for cabling alternatives.
and reconnect it to the black port labeled
Ethernet port on your modem
Wait 1 minute , then
AC Power Adapter
AC outlet .)
This end is attached
to your computer.
Do NOT unplug.
2
last .
.
turn on power to your Internet
to the port labeled 'Power'
Advance to page 6.
Open Port
Modem
`Computer'
port
on
5