DeWalt DC608-XE Instruction Manual page 19

Troubleshooting Guide (cont'd)
Tool operates, but does not drive the fastener fully
Tool operates, but no fastener driven
Jammed fastener
Low battery charge or damaged battery
Depth adjustment set too shallow
Tool not firmly applied to workpiece
Material and fastener length
too rigorous an application
Damaged or worn driver blade tip
Damaged or worn driver/return assembly
No fasteners in magazine
Wrong size or angle fasteners
Debris in nosepiece
Debris in magazine
Worn magazine
Damaged or worn driver blade
Damaged pusher spring
Wrong size or angle fasteners
Damaged or worn driver blade
Material and fastener length
Low battery charge or damaged battery
Debris in nosepiece
Debris in magazine
Worn magazine
Worn or damaged pusher spring
17
Charge or replace battery
Rotate depth adjustment wheel to a deeper
setting
See instruction manual
Choose appropriate material or fastener length
Replace driver/return assembly; see authorized
service center
Replace driver/return assembly; see authorized
service center
Load fasteners into magazine
Use only recommended fasteners
Clean nosepiece
Clean magazine
Replace magazine; see authorized service
center
Replace driver/return assembly; see authorized
service center
Replace spring; see authorized service center
Use only recommended fasteners
Replace driver/return assembly; see authorized
service center
Material or fastener length inappropriate
too rigorous an application
Charge or replace battery
Clean nosepiece
Clean magazine
Replace magazine; see authorized service center
Replace spring; see authorized service center