Troubleshooting Guide - DeWalt DC608-XE Instruction Manual

MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW. FOR MORE SERIOUS OR PERSISTENT PROBLEMS,
CONTACT A D
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, ALWAYS DISCONNECT BATTERY PACK FROM TOOL BEFORE ALL REPAIRS.
SYMPTOM
Tool doesn't turn on
(Headlights don't turn on)
Tool doesn't actuate
(Headlights on, motor does not run)
Tool doesn't actuate (Headlights flash 4 times)
Tool doesn't actuate (Headlights flash continuously)
Tool doesn't actuate (Headlights on, motor runs)
Tool doesn't actuate
(Headlights on, motor runs, driver blade stuck down)

TROUBLESHOOTING GUIDE

WALT SERVICE CENTER OR CALL (AUS) 1800 654 155 OR (NZ) 09 259 1111.
E
CAUSE
Tool internal electronics not reset
Low battery charge or damaged battery
Terminals are dirty or damaged
Contact trip lock is in a locked position
Bent contact trip
Damaged internal electronics
Motor stops running after 2 seconds
Contact trip or trigger not depressed
Damaged trigger
Bent contact trip
Contact trip lock in the locked position
Damaged internal electronics
Low battery charge or damaged battery
Jammed fastener
Jammed mechanism
Damaged internal electronics
Damaged return system
Debris in nosepiece
Damaged driver/return assembly
16
FIX
Remove battery, wait 3 seconds and reinsert
Charge or replace battery
See authorized service center
Unlock contact trip lock
See authorized service center
See authorized service center
Normal operation; release trigger or contact trip and
redepress
See instruction manual
See authorized service center
See authorized service center
Unlock contact trip lock (Sequential mode only)
See authorized service center
Charge or replace battery
Remove the battery, clear the jammed fastener, (push
driver blade back up manually if necessary) and
reinsert battery pack
See authorized service center
See authorized service center
Replace return system; see authorized service center
Clean nosepiece
Replace driver/return assembly; see authorized
service center