Advertisement
STEP 9 Position front wheel assembly to tow bar
9A
9A.
Hold the end of the tow bar with your left hand and the front wheel bracket in your right hand.
Secure the lug on each bracket plate into the holes in the tow bar so that the bracket rests snugly against the
tow bar.
Tighten the lock knob completely.
9B.
Flip the red steering lock up at the base of the fork to allow the wheel to rotate in all directions.
STEP 10 To attach stroller bar to trailer
10A
Handlebar
clamp
10A.
Loosen the lock knobs on the handlebar clamps but do not remove the lock knobs. Hold the handlebar so
that the clamps are positioned at the rear of the cabin frame.
10B.
Pinch the clamp to open it and slide the clamp over the canopy and cabin frame tubing.
10C.
Tighten the lock knob and repeat for the other side.
10D.
The product is now ready for use in stroller mode.
WARNING Always use the safety wrist strap when pushing this product in stroller mode!
TO ATTACH THE TRAILER TO A BIKE
STEP 11 Coupler attachment for bikes with rear hub nuts.
(Note: If your bicycle rear wheel has a quick-release rear axle please proceed to Steps 13 & 14)
11A
11A.
Loosen the rear bike hub nut with a wrench.
11B.
Remove the hub nut and washer from the bike.
11C.
Position the coupler plate over the axle. Replace the bike hub nut and washer and tighten by hand.
11D.
Tighten the bike hub nut securely with a wrench.
Hole in
towbar
10B
11B
9B
10C
11C
10D
11D
Advertisement
