Advertisement
Quick Links
Advertisement
Summary of Contents for Halfords 2-in-1 Bike Trailer
-
Page 1: Safety Instructions
2-in-1 Bike Trailer Owner’s manual safety instructions... -
Page 2: Prior To Assembly
PRIOR TO ASSEMBLY Your Halfords trailer is 95% factory assembled. You need only install the safety flag, and attach the wheels before it is ready to use. This initial assembly should only take around 10-15 minutes, after which all you need do now is familiarize yourself with the essential safety information within this document and you’re ready to go. -
Page 3: Assembly Instructions
ASSEMBLY INSTRUCTIONS Remove all of the contents from inside the carton and place them on a clean flat surface. Check all the contents against the parts list on page 1. Check the contents also for damage. Set the wheels to the side and remove the black plastic protective caps from the ends of the axles. Remove the rain canopy and flag pole assembly from inside the trailer. - Page 4 STEP 3 Adjust the sling seat Area of detail in photo 3B Front view of the trailer with the crossbar secured in place. To provide more comfort, the sling seat can be adjusted by pulling on one or both sets of straps that run underneath the bottom of the seat.
- Page 5 STEP 6 Attach the wheels to the quick-release brackets and make sure they are secure Locate the rear wheel brackets on each side of the trailer and read the warnings carefully. Push one wheel axle completely through the bracket hole until you hear the axle click into place. IMPORTANT! Pull firmly on each wheel to ensure the lock mechanisms are securely engaged! STEP 7 Extend and secure the tow bar Bracket...
- Page 6 STEP 9 Position front wheel assembly to tow bar Hole in towbar Hold the end of the tow bar with your left hand and the front wheel bracket in your right hand. Secure the lug on each bracket plate into the holes in the tow bar so that the bracket rests snugly against the tow bar.
- Page 7 STEP 12 Attach trailer tow bar to bike 12A. Tighten the bike hub nut securely with a wrench. 12B. Locate the front end of the tow bar around the coupler. 12C. Push the quick release pin through the holes in the tow bar and the coupler and fasten securely. 12D.
- Page 8 STEP 15 Install the safety flag Flag pole Sleeve 15A. Connect the flagpole sections and find the small opening near the top left edge of the canopy. 15B. Slide the end of the flagpole through the opening in the canopy. 15C.
- Page 9 REMOVAL, DISASSEMBLY, AND STORAGE INSTRUCTIONS Removal of the trailer from the bike 1. Remove children from inside the passenger compartment. 2. Unclip the tow bar safety strap from the “D” ring. 3. Loop the strap back around the bike frame tube so that the strap is free of the bike frame. 4.
- Page 10 WARNING Not for use at high speeds! Do not exceed 10 MPH! WARNING Never ride a bike or pull this trailer at night! WARNING Be aware of exposure hazards such as wind-chill and heat exhaustion by less-active trailer passengers in prolonged exposure in colder temperatures, or by extended periods in warmer temperatures without adequate ventilation and hydration.