Operation - MHSC WEF33 Homeowner's Installation And Operating Instructions Manual

Operation

The controls are located behind the hinged control panel door. If using heater, control
panel door will be hot during and immediately after operation. Open door by pressing
on right side. A spring magnet will push door forward. Pull door down to open.
1. Plug in electric fireplace or if hard-wired to 40V AC, turn switch on.
. Turn on lighted power switch. Figure 6
3. Adjust Flame/Ember/Backlight/Heater to desired settings using the control pad on
fireplace (Figure 6) or remote control. Figure 7. Figure 8 shows fireplace settings
available. Default settings are circled. Press control pad or remote control buttons
once and release to adjust settings.
NOTE: When on, ember bed will lighten and darken automatically to simulate real
embers.
The heater is pre-set to the following temperatures.
•
High will shut off when room reaches approximately 86°F (30°C).
•
Medium will shut off when room reaches approximately 79°F (6°C).
•
Low will shut off when room reaches approximately 7°F (°C).
NOTE: Fan on heater will continue to run for 5-7 seconds after heater has been
turned off.
4. When using remote control, aim remote at sensor located in center of unit just
above the log set. IMPORTANT: This remote control must remain within 0 feet (6
m) of fireplace to be effective.
5. When power switch is turned off, fireplace settings go back to default. Figure 8
Figure 6
Heater
FP391
Flame
Heater Control
Control
FP2391
controls
POWER
FLAME EMBER
BACKLIGHT HEATER
Figure 7
FP2392
68D5301
Remote control
Power
Flame Ember Backlight
Ember
Control
Backlight Control
(Default settings are circled)
HEATER
FLAME
EMBER
BACKLIGHT
Lighted Power
Switch
Fireplace Settings
Off Low Medium
Off Low Medium
Off Low Medium
Off Low
Figure 8
High
High
High
High
9