Assembly; Fitting The Loop Handle; Assembling And Dismantling The Two-Piece Shaft - Husqvarna 326C, 326L, 326LS, 326LX-Series, 326LDX-Series Operator's Manual

Fitting the loop handle

(326C)
• Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.
• Fit the screw, securing plate and wing nut as shown in the
diagram.
• Tighten the wing nut.
Fitting the loop handle
(326L, 326Lx, 326LDx)
• Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
• Slide the spacer into the slot in the loop handle.
• 326L: Fit the nut, washer and screw.
326LX/326LDX: Fit the nut, knob and screw. Do not
overtighten.
• Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.
10 –
English

ASSEMBLY

Assembling and dismantling the
two-piece shaft
(326LDx)
Assembly:
• Make sure the knob is loose.
• Align the cut-out in the lower part of the shaft with the
coupling locking tab on the upper part of the shaft. Then
lock the sections together.
• Tighten the knob.
Dismantling:
• Undo the knob (at least three turns).
• Push the knob towards the coupling.
• Carefully twist the lower half of the shaft to unlock it.
• Hold both parts of the shaft and pull the lower part of the
shaft out of the coupling.