Nokia 6700 classic User Manual page 45

Nokia battery authentication guidelines
Always use original Nokia batteries for your safety. To check
that you are getting an original Nokia battery, purchase it
from a Nokia authorised service centre or dealer, and inspect
the hologram label using the following steps:
Authenticate hologram
1 When you look at the hologram on the label, you should
see the Nokia connecting hands symbol from one angle
and the Nokia Original Enhancements logo when
looking from another angle.
2 When you angle the hologram left, right, down and up,
you should see 1, 2, 3 and 4 dots on each side
respectively.
Successful completion of the steps is not a total assurance of
the authenticity of the battery. If you cannot confirm
authenticity or if you have any reason to believe that your
Nokia battery with the hologram on the label is not an
authentic Nokia battery, you should refrain from using it, and
take it to the nearest Nokia authorised service centre or
dealer for assistance.
To find out more about original Nokia batteries, see
www.nokia.com/battery.
Care and maintenance
Your device is a product of superior design and craftsmanship
and should be treated with care. The following suggestions
will help you protect your warranty coverage.
Keep the device dry. Precipitation, humidity, and all
•
types of liquids or moisture can contain minerals that
will corrode electronic circuits. If your device does get
Product and safety information
wet, remove the battery, and allow the device to dry
completely before replacing it.
Do not use or store the device in dusty, dirty areas. Its
•
moving parts and electronic components can be
damaged.
Do not store the device in hot areas. High temperatures
•
can shorten the life of electronic devices, damage
batteries, and warp or melt certain plastics.
Do not store the device in cold areas. When the device
•
returns to its normal temperature, moisture can form
inside the device and damage electronic circuit boards.
Do not attempt to open the device other than as
•
instructed in this guide.
Do not drop, knock, or shake the device. Rough
•
handling can break internal circuit boards and fine
mechanics.
Do not use harsh chemicals, cleaning solvents, or strong
•
detergents to clean the device.
Do not paint the device. Paint can clog the moving parts
•
and prevent proper operation.
Use a soft, clean, dry cloth to clean any lenses, such as
•
camera, proximity sensor, and light sensor lenses.
Use only the supplied or an approved replacement
•
antenna. Unauthorised antennas, modifications, or
attachments could damage the device and may violate
regulations governing radio devices.
Use chargers indoors.
•
Always create a backup of data you want to keep, such
•
as contacts and calendar notes.
To reset the device from time to time for optimum
•
performance, power off the device and remove the
battery.
These suggestions apply equally to your device, battery,
charger, or any enhancement. If any device is not working
properly, take it to the nearest authorised service facility for
service.
Disposal
The crossed-out wheeled-bin symbol on your product,
literature, or packaging reminds you that all electrical and
electronic products, batteries, and accumulators must be
taken to separate collection at the end of their working life.
This requirement applies to the European Union and other
locations where separate collection systems are available. Do
not dispose of these products as unsorted municipal waste.
By returning the products to collection you help prevent
uncontrolled waste disposal and promote the reuse of
material resources. More detailed information is available
45