F Board - Sony VPL-HS51 Service Manual

8. Remove the shield plate (BD) in the direction shown
by the arrow.
9. Remove the shield plate (BU) in the direction shown
by the arrow.
10. Remove the four hooks of the holder (BD), then
remove the holder (BU) and lamp power supply board.
11. Disconnect the harness from the connector on the lamp
power supply board.
Shield plate (BU)
Harness
Hook
Shield plate (BD)
Installation
12. Install the lamp power supply board in the reverse
order of steps 5 to 11.
13. Assemble this unit in the reverse order of steps 1 to 4.
VPL-HS50/HS51
A
Holder (BU)
Lamp power supply
board
Hooks
B
Holder (BD)
A
B

1-4-7. F Board

Removal
1. Remove the cabinet. (Refer to Section 1-3.)
2. Disconnect the five harnesses from the connector
(CN10 to CN14) on the F board.
3. Remove the two screws, then remove the F board.
F board (Side A)
CN14 CN11
CN12
CN10 CN13
Installation
4. Install the F board in the reverse order of steps 2 and 3.
5. Attach the cabinet.
Harnesses
BTP
3 x 12
F board
Harnesses
1-9