Pontiac Wave 2008 Owner's Manual page 179

The previous volume setting is maintained whenever the
radio is turned on. The volume can be adjusted by
using the volume knob.
Finding a Station
AM: Press this button to switch to an AM station. The
display shows the selection.
FM: Press this button to switch to an FM station. The
display shows the selection.
( )
TUNE: Press the TUNE arrows to select radio
stations.
Press the up TUNE arrow to increase or the down
TUNE arrow to decrease the radio frequencies.
¦ ¥
SEEK: Press the SEEK arrows to seek radio
stations.
Press the up SEEK arrow to seek the next radio station
or the down SEEK arrow to seek the previous radio
station.
SCAN/AST: Press this button to scan radio stations.
The radio goes to a station, plays for a few seconds,
then goes to the next station. Press this button again to
stop scanning.
The radio only scans stations with a strong signal that
are in the selected band.
AST (Automatic Store)
Six FM1 preset stations with the strongest reception in
the region can be automatically stored. Press the
AST button for more than one second. The display
shows AUTO SCANNING and then SCANNING flashes
on the display. Once the stations are stored, the
radio switches to FM1 and the first preset station begins
to play. FM-A displays while listening to the automatic
stored stations. Press the AM or FM button to cancel
automatic store.
Setting Preset Stations
Up to 36 stations (six FM1, six FM2, six FM-A, six AM1,
six AM2, and six AM-A), can be programmed on the
six numbered buttons, by performing the following steps:
1. Turn the radio on.
2. Press the AM or FM button to select FM1, FM2,
FM-A, AM1, AM2, or AM-A.
3. Tune in the desired station.
4. Press and hold one of the six numbered
pushbuttons for more than two seconds. The
channel number (CH#1 through CH#6) flashes on
the display when the station has been set.
When that numbered preset button is pressed, that
preset station returns.
5. Repeat the Steps 1 through 4 for each preset
button.
3-65