Video Section Adjustments; Preparations Before Adjustments; Equipment To Required - Sony CCD-TRV128 Service Manual

CCD-TRV128/TRV228/TRV228E/TRV328/TRV428/TRV428E

6-3. VIDEO SECTION ADJUSTMENTS

3-1.

PREPARATIONS BEFORE ADJUSTMENTS

Use the following measuring instruments for video section adjust-
ments.
Note: NTSC model: CCD-TRV128/TRV228/TRV328/TRV428
PAL model: CCD-TRV228E/TRV428E

3-1-1. Equipment to Required

1) TV monitor
2) Oscilloscope (dual-phenomenon, band width above 30 MHz
with delay mode) (Unless specified otherwise, use a 10 : 1
probe)
3) Frequency counter
4) Digital voltmeter
5) Audio level meter
6) Audio distortion meter
7) Regulated power supply
8) NTSC alignment tapes
• For tracking adjustment (WR5-1NP)
Parts code: 8-967-995-02
• For video frequency characteristics adjustment (WR5-7NE)
Parts code: 8-967-995-13
• For checking Standard 8 mode operations
For LP (WR5-4NL)
Parts code: 8-967-995-51
For SP (WR5-5NSP)
Parts code: 8-967-995-42
Note: The following alignment tapes can also be used.
WR5-4NSP (8-967-995-41)
• For checking Hi8 mode operations
For LP (WR5-8NLE)
Parts code: 8-967-995-52
For SP (WR5-8NSE)
Parts code: 8-967-995-43
• For BPF adjustment (WR5-11NS)
Parts code: 8-967-995-71
9) PAL alignment tapes
• For tracking adjustment (WR5-1CP)
Parts code: 8-967-995-07
• For video frequency characteristics adjustment (WR5-7CE)
Parts code: 8-967-995-18
• For checking Standard 8 mode operations
For LP (WR5-4CL)
Parts code: 8-967-995-56
For SP (WR5-5CSP)
Parts code: 8-967-995-47
Note: The following alignment tapes can also be used.
1) WR5-3CL (8-967-995-36)
2) WR5-4CSP (8-967-995-46)
• For checking Hi8 mode operations
For LP (WR5-8CLE)
Parts code: 8-967-995-57
For SP (WR5-8CSE)
Parts code: 8-967-995-48
• For BPF adjustment (WR5-11CS)
Parts code: 8-967-995-76
10) Adjustment remote commander (J-6082-053-B)
11) CPC jig connector (J-6082-539-A)
12) I/F unit for LANC control (J-6082-521-A)
6-26