3Com Switch 7700 Configuration Manual page 101

Table 3 Configuring a Default Route
Operation
Delete a default route
Parameters for default route are the same as for static route.
Deleting All Static Routes
You can use the undo ip route-static command to delete one static route. The
Switch 7700 also provides the delete static-route all command for you to delete
all static routes at one time, including the default routes.
Perform the following configuration in system view.
Table 4 Deleting All Static Routes
Operation
Delete all static routes
Displaying and Debugging Static Routes
After you configure static and default routes, execute the display command in all
views, to display the static route configuration, and to verify the effect of the
configuration.
Table 5 Displaying and Debugging the Routing Table
Operation
View routing table summary
View routing table details
View the detailed information of a specific
route
View the route filtered through specified basic
access control list (ACL)
View the route information that through
specified ip prefix list
View the routing information found by the
specified protocol
View the tree routing table
View the integrated routing information
As shown in the Figure 3, the masks of all the IP addresses in the figure are
Example: Typical Static
Route Configuration
255.255.255.0. All the hosts or switches must be interconnected in pairs, by
configuring static routes.
Static Routes
Command
undo ip route-static 0.0.0.0 { 0.0.0.0 | 0 } {
interface-name | gateway-address } ]
Command
delete static-routes all
Command
display ip routing-table
display ip routing-table verbose
display ip routing-table ip-address
display ip routing-table acl { acl-number |
acl-name } [ verbose ]
display ip routing-table ip-prefix
ip-prefix-number [ verbose ]
display ip routing-table protocol protocol [
inactive | verbose ]
display ip routing-table radix
display ip routing-table statistics
93