Fisher Minute Mount 2 system Owner's Manual page 55

Wing Positions
Moving the control lever from the center position
toward the word WING or WING IN/OUT, on either
side of the face of the control body will cause
either wing to move independently of the other as
described in the following table.
NOTE: If control function times out before
desired blade movement is complete, release
the lever to the center position, then move
back into the desired function.
SECURITY GUARD™ System (1, 2, 3, 4)
Moving the control lever from the center
position toward any of the four digits on the
face of the control body will also operate the
SECURITY GUARD system (if equipped). See
SECURITY GUARD System in this section for
more information.
Lit. No. 44224, Rev. 14
OPERATING YOUR SNOWPLOW
Function Description of Operation
Move the control lever toward the left side
of LOWER on the control face to move
the left wing. The fi rst time the lever is
moved into the slot after the control is
L WING turned ON or another function is used,
the wing will extend. Repeated use of
(WING lever in the same slot, without using
IN/OUT) another function, results in movement in
the opposite direction from the previous
movement. Function times out after
3.0 (XtremeV™), 3.25 (XLS™ – IN) or
3.75 seconds (XLS – OUT).
Move the control lever toward the right
side of LOWER on the control face to
move the right wing. The fi rst time the
lever is moved into the slot after the
R WING control is turned ON or another function is
used, the wing will extend. Repeated use
(WING of lever in the same slot, without using
IN/OUT) another function, results in movement
in the opposite direction from the
previous movement. Function times out
after 3.0 (XtremeV), 3.25 (XLS – IN) or
3.75 seconds (XLS – OUT).
56 August 15, 2011