Attaching Snowplow To Vehicle - Fisher Minute Mount 2 system Owner's Manual

ATTACHING SNOWPLOW
WARNING
Keep 8' clear of the blade drop zone when
it is being raised, lowered or angled. Do
not stand between the vehicle and blade
or directly in front of blade. If the blade
hits you or drops on you, you could be
seriously injured.
WARNING
Inspect snowplow components and bolts
for wear or damage whenever attaching
or detaching the snowplow. Worn or
damaged components could allow the
snowplow to drop unexpectedly.
Lit. No. 44224, Rev. 14

ATTACHING SNOWPLOW TO VEHICLE

NOTE: The blade must be in the straight
position when attaching or detaching the
snowplow.
NOTE: Use dielectric grease to prevent
corrosion on all connections.
Attaching Steps:
1. Pull pin release handle and push down to pull
out connecting pins.
2. Drive vehicle slowly to engage pushplates into
attachment arms.
HT Series™ Blades ONLY: Attach all
electrical connectors. With the ignition in
the "ON" position, turn ON the control and
activate the FLOAT mode.
3. Stand in front of blade. Fully raise pin release
handle to release connecting pins.
34 August 15, 2011