Table of Contents
Advertisement
Estate Air-Whirlpool Owner's Manual & Installation Guide
BATHSIDE CONTROL SYSTEMS
3:
BLOWER CYCLES
2: ON/OFF BLOWER
1: ON/OFF PUMP
KeyPad Functions
1: On/Off Pump
1st Press: The pump starts
2nd Press: The pump stops
2: ON/OFF BLOWER
1st Press: The blower starts
2nd Press: The blower stops
3: BLOWER CYCLES
1st Press: Wave Cycle - Speed goes gradually from maximum to minimum.
2nd Press: Pulse Cycle - Speed goes from minimum then straight back to maximum.
3rd Press: Returns to maximum speed
4: SPEED INCREASE
1st Press: Press and hold to increase the blower speed,
release pressure at the desired speed.
When in cycles mode, increases the speed at which the cycle operates.
5: SPEED DECREASE
1st Press: Press and hold to decrease the blower speed,
release pressure at the desired speed.
When in cycles mode, decreases the speed at which the cycle operates.
Advanced Programming
DRYING CYCLE WITH WATER DETECTORS
The drying cycle will activate 20 minutes after the bathtub is emptied
even if the system was not used.
The blower touch LED blinks while waiting for the purge cycle.
INTEGRATED 20 MINUTE AUTOMATIC TIMER
Integrated 20 minute automatic timer on the complete system.
Count down starts with the last system turned on.
Figure 6
Aquatic
OPERATION
4: SPEED INCREASE
5: SPEED DECREASE
OR
LED
ON
OFF
ON
OFF
ON
BLINK
OFF
ON
(WHEN PRESSED)
ON
(WHEN PRESSED)
15
Advertisement
Table of Contents
