Charging The Battery - HTC MTC Pulse User Manual

3. Press the microSD card all the way in until it clicks into place.
To remove the storage card
Press the storage card in to eject it from the slot.
Note If you want to remove the storage card while the phone is on, see
"To remove the storage card while the phone is on" later in this chapter.

1.3 Charging the Battery

New batteries are not charged when shipped. Before you start using
your phone, you need to install and charge the battery. Some batteries
perform best after several full charge/discharge cycles.
To charge the battery
1. Connect the USB connector of the Charging Cable to the sync
connector on the bottom of your phone.
2. Connect the other end of the Charging Cable to the AC Charger.
3. Select the AC Charger plug adapter that is appropriate for your
locale and insert it into the AC Charger.
4. Plug in the AC Charger to an electrical outlet to start charging
the battery.
Charging is indicated by a solid amber light in the Notification LED.
As the battery is being charged while the phone is on, the charging
battery icon (
After the battery has been fully charged, the Notification LED shows
) is displayed in the status bar of the Home screen.
Phone Basics