Step 3. Electrical Wiring - Carrier Air V Owner's Manual

DO NOT USE DUCT TAPE ON OR AROUND FABRIC DUCT COLLAR.
8
Pull fabric tight. This will prevent the material from
gathering inside the discharge duct.
STEP 3 - ELECTRICAL WIRING
ROUTING 115V AC WIRING
MAKE SURE THAT ALL POWER SUPPLY TO THE UNIT IS DISCONNECTED BEFORE PERFORMING ANY WORK ON THE
UNIT TO AVOID THE POSSIBILITY OF SHOCK OR INJURY AND/OR DAMAGE TO THE EQUIPMENT.
After the interior ceiling assembly frame is properly secured to the roof top air conditioner, the following electrical
connections must be performed.
WARNING
WARNING
1
2
3
Figure 5
WHEN USING INSULATED CABLES, STRIP THE OUTER JACKET
BACK TO EXPOSE 4-6 INCHES OF THE INSULATED LEADS. STRIP
THE INDIVIDUAL WIRE LEAD ENDS FOR THE CONNECTION.
(EXPOSE ABOUT 3/4" OF BARE WIRE.) THEN TIGHTEN UP ON
THE CABLE. DO NOT OVERTIGHTEN! THIS COULD RESULT IN
PINCHING THROUGH THE PLASTIC WIRE INSULATION AND
CAUSE A SHORT OR "HOT" WIRES. (YOU COULD GET
SHOCKED.) THE CLAMP IS INTENDED FOR STRAIN RELIEF OF
THE WIRES, AND SLIGHT PRESSURE IS USUALLY SUFFICIENT TO
ACCOMPLISH THIS.
9
Fasten each side of the fabric duct with fitting
the duct plate to the ceiling assembly plate with
5 screws (See , Figure 4). Trim any excess fabric
that may extend beyond edge of duct plate.
Route a copper, with ground, supply wiring with
minimum, #12 A WG from its power source to the
junction box. Do not attach them at this time.
Take the roof top air conditioner electrical harness and
plug it into the side of the selector switch control box.
Make sure that the "ridged" side of the plug is aligned
and matched with the "ridged" side of the selector
switch control box connection. DO NOT USE EXCESSIVE
FORCE (See Figure 5).
Remove the junction box cover (1 screw). Take the
supply wire and slide it into the back of the junction box
through the strain relief that is provided.
CAUTION
'
OWNER S GUIDE -10