Table of Contents
Advertisement
7 • Completing Your Installation With or Without a Light Fixture
Steps 7-1 – 7-4
Housing
Assembly
Screw
10
Hunter Fan Company
Your Hunter fan comes with a switch housing assembly and an
optional light fixture. is feature gives you the option of installing the
fan with OR without the included light fixture. e steps below direct
you whether or not you are installing a light fixture.
WARNING: Use only the light fixture supplied with this fan model.
7-1. To attach the upper switch housing, partially install two housing
assembly screws into the switch housing mounting plate.
7-2. Feed the upper plug connector through the center opening of the
housing.
7-3. Align the keyhole slots in the housing with the housing assembly
screws.
7-4. Turn the housing counterclockwise until the housing assembly
screws are firmly situated in the narrow end of the keyhole slots.
Install the remaining housing assembly screw into the housing.
Upper
Switch
Tighten all three screws firmly.
Housing
7-5. If you want to install the light fixture, proceed with step 7-6
now.
If you do not want to install the light fixture, you need to
uninstall it now. See "Uninstalling the Light Fixture" on page 12.
Once you have uninstalled the light fixture, continue with step
7-6.
CAUTION: Make sure the upper switch housing is securely
attached to the switch housing mounting plate. Failure to properly
attach and tighten all three assembly screws could result in the
switch housing and light fixture falling.
42605-01 • 02/16/06
Advertisement
Table of Contents
