Set Up Instructions; Strainer & Plunger Valve Setup - Intex 633 Owner's Manual

POOL OUTLET - STRAINER & PLUNGER VALVE SET-UP
The strainer grid prevents large objects from jamming and/or damaging the
filter pump and the plunger valve assembly prevents water from flowing into
the filter pump while the filter cartridge is being placed or cleaned. If your
pool has inflatable top ring, install the strainer, nozzle and plunger valve
before inflating the pool liner top ring.
1. Grasp the strainer and plunger valve
mechanism.
2. In a counter-clockwise motion unscrew
plunger valve union from the threaded
strainer connector (14). Be careful not to
lose the step rubber washer (11). Place
the plunger valve on the ground in a safe
place (see drawing 1).
3. In a counter-clockwise motion unscrew
the strainer nut (12) from the threaded
connector (14). Leave the flat
washer (13) on the connector (14).
4. Install the strainer and plunger valve at the
lower position of pool outlet (marked "+").
From the inside of the pool liner insert
the connector (14) into one of the pre-cut
holes with the washer remaining on the
connector to be placed against the inside
of the liner wall.
5. With the flat side of the strainer nut (12)
facing the outside wall of the liner in a
clockwise motion screw the strainer nut (12)
back onto the threaded connector (14)
(see drawing 2). Before assembly, lubricate
the threads with a petroleum jelly.
6. Finger tighten the strainer grid (16) and
the strainer nut (12) onto the threaded
connector (14).
7. Grasp the plunger valve assembly. Make
sure the step washer (11) is in place.
8. In a clockwise motion screw the plunger
valve union back onto the threaded
connector (14) (see drawing 3).
9. Examine the plunger valve to see if the
handle is pushed fully down to the "0/1"
position. If not, then grasp the handle at
the top and push down turning the
handle in a clockwise direction until the
plastic protruding notch anchors in
the "0/1" position. This will prevent
water from flowing out during filling
(see drawings 4.1 & 4.2).
SAVE THESE INSTRUCTIONS
(109) MODEL 633 FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 09/26/2008
12
1
2
English
1
2
1
2
INSIDE
LINER WALL
13 14 16
3
1
2
4.1
INSIDE
LINER
WALL
4.2
Page 7
109