Operating Instructions - Intex 633 Owner's Manual

Krystal clear filter pump

Hide thumbs

Table Of Contents

Table of Contents

1. Make sure the filter pump switch is "OFF". The switch is located on the motor

housing.

2. Connect the power cord to a GFCI protected electrical outlet.

Risk of electric shock. Connect this product only to a grounding type

receptacle protected by a ground-fault circuit interrupter (GFCI). Contact a

qualified electrician if you cannot verify that the receptacle is protected by

a GFCI.

To prevent air lock, open the lower plunger valve (connected inlet hose)

first and then the upper plunger valve (connected outlet hose). Open air

release valves, wait until water starts to flow out of the air release valves,

close air release valves.

3. Grasp a plunger valve handle. Turn the handle counter-clockwise, pull up until

it stops, and then turn it clockwise until the metal protruding notch anchors in

the "0/1" position. Repeat for the 2nd plunger valve. This opens the valves to

allow water to flow into the filter pump.

4. With water flowing into filter pump, the water pressure will allow the air trapped

inside to escape from the air release valves (2 & 7). When all the air has

escaped water will flow out of the valves (2 & 7). When this occurs gently finger

tighten the valves (2 & 7) in a clockwise direction.

5. Turn the switch "ON". The filter pump is now filtering the water.

6. Operate the filter pump until the desired water clarity is obtained.

FILTER CARTRIDGE CLEANING OR REPLACEMENT

It is recommended that the filter cartridge be replaced at least

every 2 weeks.

1. Make sure the filter pump is turned off, and disconnect the power cord from the

electrical outlet.

2. Close both plunger valves. Grasp a plunger valve handle. Turn the handle

counter-clockwise, push down until it stops and then turn it clockwise until the

plastic protruding notch anchors in the "0/1" position. Repeat for the 2nd

plunger valve. This prevents the water from flowing out of the pool.

3. Gently turn the top air release valve 1-2 turns in a counter-clockwise direction.

This will allow the housing cover to be easily removed.

4. In a counter-clockwise direction remove the filter housing collar (1). Place it in a

safe location.

5. Remove the housing cover (4).

6. Remove the "OLD" filter cartridge.

7. Examine the inside of the filter housing.

SAVE THESE INSTRUCTIONS

(109) MODEL 633 FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 09/26/2008