Technical Specifications - Philips HD8030 User Manual

EnglisH
28
Problem
The coffee is too weak.
The coffee is not hot
enough.
The 'water tank empty'
light, 'coffee grounds
container full' light,
'bean-funnel empty' light
and CALC CLEAN light
flash simultaneously.
The grinding degree
changed to a coarser
setting.
Feature
Nominal voltage
Power rating
Material
Cord length
Water tank capacity
Coffee grounds container capacity
Capacity of coffee jug
4203_000_7242_2_DFU-Luxury_A5_v1.indd 28
Possible solution
Choose a bean-funnel with a stronger coffee blend.
HD8030 only: Use the coffee strength button to set the coffee strength to 'strong'.
You can increase the strength of the coffee on all models by reducing the
amount of water used for brewing. To stop the brewing process at any
moment, press the same cup button (1-cup button or 2-cup button) that you
pressed to start brewing coffee.
If the temperature has decreased over time, descale the coffeemaker
(see chapter 'Descaling the coffeemaker').
Perform a manual rinsing cycle to preheat the inside of the coffeemaker
(see chapter 'Using the coffeemaker', section 'Manual rinsing cycle').
Rinse the jug with hot water before you start brewing coffee.
Do not use milk that comes directly out of the fridge.
Preheat the cups by rinsing them with hot water. Use thin-walled cups,
because they absorb less heat from the coffee than thick-walled cups.
Try to reset the coffeemaker. To reset the coffeemaker, switch it off and unplug
it. Remove the brewing unit, the bean-funnel, the coffee grounds container and
the water tank. Then put the brewing unit, the bean-funnel, the coffee grounds
container and the water tank back. Plug in the coffeemaker and switch it on. You
may have to repeat this 2-3 times to make all the lights go out. If the problem
persists, go to www.philips.com/senseo-sarista/support or contact the
consumer care centre.
It is recommended to adjust the grinding degree when you notice this. These
adjustments are not required regularly. You can adjust the coffee grinder with
the grinding degree adjustment tool which is placed behind the service door
next to the brewing unit (see chapter 'Cleaning and maintenance').

Technical specifications

Value / location
Inside of service door
Inside of service door
Plastic
0.8 m
1250ml
10 cakes
6 cups
1/9/13 1:38 PM