Table of Contents
Advertisement
3.1.27 Transweeper
This function is used to detect a wireless microphone or any other bug using
radio and locate the place where it is installed. If you previously assign any
frequency expected for bugging purposes to the memory channel or auto
memory channel, the DJ-X2000 will scan for that frequency. The settings for
bank link and channel skipping will become valid.
1
Turn ON the transweeper.
3
2
1
6
5
4
9
8
7
0
CL R
VFO mode
MR mode
PMS mode
2
Check for bugging.
In this state, control the sound volume and the orientation
of the DJ-X2000. If the existence of any bug is detected,
the display changes as shown here.
3
Search for the location of the bug while slowly bringing the DJ-X2000
closer to that bug.
You can find the distance to the location of the bug according to the changes on
the display.
• As the DJ-X2000 comes closer to the bug
Press the
F
key, and then press
TF
the
key with
ENT
the display.
The transweeper will start.
The scanning varies depending on the basic mode in
use.
The scanning is performed from the currently received
frequency toward higher frequencies. The scanning
direction is changed using the dial or UP/DOWN key.
Only the specified bank is scanned. The settings for
bank link and channel skipping become valid. Pressing
A~B S
the
key starts the scanning.
SCN
The scanning is performed only within the programmed
scanning range that you have specified.
shown on
T F
(
A
1
(
A
1
)
1 5 4 .
)
1 5 4 .
55
Advertisement
Table of Contents
