® IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING THIS AIR PURIFIER. 1. This Air Purifier is designed for use on a flat, level surface and may not work properly on an uneven surface. ALWAYS place this Air Purifier on a firm, level surface. ALWAYS place the Air Purifier at least six (6) inches away from walls and heat sources such as stoves, radiators, or heaters.
Page 3
INTRODUCTION Thank you for purchasing the QuietFlo™ True HEPA Air Purifier from Hunter Fan Company. You have purchased our latest development in portable Air Purification Systems. This system has been developed to improve the quality of the air you breathe. Our QuietFlo™...
2. Place your QuietFlo™ Air Purifier on a firm, flat surface. 3. Before turning the Air Purifier ON, you need to open the front grille. For Models 36114/36115/36144/36145: To release the front grille, press the tabs until the front grille slides easily over the tabs. Refer to Figures 2a on page 5.
Page 5
Front Grille Pre-filter HEPA Filter Figure 2a - Models 36114 & 36115 Inside View of Front Grille Figure 2b - Models 36114, 36115, 36144 & 36145 41481-01 10-5-2001 Hook Tape Grille Vents Hook Tape ® Press to Open Front Grille...
Page 6
® Front Grille Pre-filter HEPA Filter Figure 3a - Models 36259 & 36260 Front Grille Pre-filter HEPA Filter Figure 3b - Models 36394 & 36395 Hook Tape Inside View of Front Grille Hook Tape Figure 3c - Models 36259 & 36260 Control Panel Grille Vents Inside View of...
OPERATING YOUR AIR PURIFIER Models 36114, 36115, 36144, 36145, 36259, 36260: On/Speed Control: Rotate the Speed Control knob to set the desired speed. As you rotate the knob clockwise, the fan speed changes from off to low to medium to high. Turn the knob counter clockwise to decrease the fan speed or turn the unit off.
® To reset the pre-filter or filter counters before the indicators are lit: In some environments, you may want to change the pre-filter or filter more frequently than indicated by the filter indicators. This procedure allows you to reset the pre-filter or filter counter before the indicators are lit.
CHANGING THE PRE-FILTER In a typical environment, the pre-filter should be changed every 2000 hours (approximately 3 months of use) to maintain proper odor-removing capability and overall filtration performance. Changing the pre-filter regularly will also help extend the life of the HEPA filter. If necessary, the pre-filter can be changed more frequently.
The model number of your air purifier is located on the rating sticker on the back of the unit. The replacement filter model numbers are listed in the table below. Air Purifier Model No. 36114 36115 36144 36145 36259...
® ELECTRICAL CORD STORAGE Models 36114, 36115, 36144, 36145: For your convenience, this air purifier has cord wrap posts for easy storage of the electrical cord. The cord wrap posts are located on the back of the air purifier in the bottom corners.