Trane 18-HD64D1-4 Installation Manual page 13

Installer Setup Menus and Options (continued)
Menu
5.2.6 ADVANCED

SENSORS

5.2.7 ADVANCED

ZONING

Please refer to the Zone Panel Installer's Guide for detailed information.
18-HD64D1-4
Setting
 Select Outdoor Temperature Sensor................................................ None
 Calibrate Outdoor Temperature Sensor - Degrees .......................... +/- in 5° Increments
 Calibrate Indoor Temperature Sensor - Degrees ............................. Zone X in +/- 5° Increments
 Calibrate RH Sensor ........................................................................ Zone X in +/- 5° Increments
Thermostat Humidity Sensor ........................................................... Disable
 Damper Travel Time ......................................................................... 15 - 60 Seconds
 Auto Detect Damper ........................................................................ No, Yes
 Detected Dampers ........................................................................... 2 - 8
 Run Auto Zone Airflow Capacity ...................................................... No, Yes
 Auto Zone Airflow Capacity Adjustment ........................................... Normal
 Airflow Capacity - % of Total ............................................................ 25% - 100%
 Voting Zones .................................................................................... No, Yes
 Indoor Heating Airflow Offset % (above and below cooling airflow) . -50 - +50, 0
 Discharge Temperature Limit - Cooling ............................................ Normal (38), Extended (34)
 Discharge Temperature Limit - Compressor Heating Only ............... Normal (116), Extended (128)
 Discharge Temperature Limit - Compressor Heating w/Aux Heat .... Normal (160), Extended (170)
 Heating Fuel Type ............................................................................ Gas
 Discharge Temperature Limit - Gas Furnace Heating ...................... Normal (135), Extended (145)
 Discharge Temperature Limit - Oil Furnace Heating ........................ Normal (160), Extended (170)
 Discharge Temperature Limit - Hydronic Heating ............................ Normal (135), Extended (145)
Available Options
Sensor Wired to Control
CLII/AccuLink Outdoor Sensor
Sensor Wired to Relay Panel
Enable
More Aggressive
Less Aggressive
Oil
13