Important information ⚠ ⚠ This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concer- ning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
About your heat pump Product description Danfoss DHP-R Eco is a heating system for heating and hot water if an external water heater is installed. It has a compressor developed solely for heat pumps. Danfoss DHP-R Eco is equipped with control equipment which is presented in a graphical display. The control equipment is also prepared for monitoring via the internet.
Water heater Danfoss DHP-R Eco can also produce hot water for an external water heater. The water temperature of the hot water tank is controlled by the control switch and cannot be adjusted.
Operating instructions See separate manual for the control system. Checking the coolant circuit pressure The brine circuit must be filled with the correct amount of fluid otherwise the installation may become damaged. Ensure that system has the necessary pressure, however, not above maximum pressure of 6 bar. See the installation instructions when filling brine: Filling the coolant system.
Troubleshooting Alarm Message Meaning Cause Remedy Low pressure error - The Not enough fluid in the brine sys- Contact your installer. LOW PRESS ERROR compressor stops and there tem. is no hot water production. Air in the brine system. Blocked filter in the brine system. HIGH PRESS High pressure error - The Insufficiently opened radiator/floor...
Terms and abbreviations Evaporator In the evaporator, energy from the heat source is absorbed by the refrigerant passing through the evaporator. The refrigerant turns into gas. (See “Heat Pump Principle” for further informa- tion.) INTEGRAL “INTEGRAL” is the heat system’s energy balance. Heat generation is controlled by a calculated requirement.
Installation and commissioning have been carried out by: Piping installation Date: Company Name: Telephone no.: Electrical Installation Date: Company Name: Telephone no.: System adjustment Date: Company Name: Telephone no.: Danfoss AS retains the right to make changes to components and specifications without prior notice. VUIFK102...
Page 12
If these instructions are not followed during installation, operation and maintenance Danfoss AS’s liability according to the applicable warranty is not binding. Danfoss AS • Box 950 • SE-671 29 Arvika www.danfoss.com VUIFK102...