If Something Goes Wrong; Before You Call For Service - GE Spacemaker JVM1530 Owner's Manual

DTP_49-40542.qxd 2/22/2007
Problem
Oven will not
start
Floor of the oven is
warm, even when
the oven has not
been used
"LOC" appears
on display
Vent fan will not
turn off
"BAD PROBE"
appears on display
"PLEASE INSERT
PROBE " appears
on display
"SENSOR ERROR"
appears on display
36
11:03 AM Page 36

If Something Goes Wrong

Before You Call For Service

Possible Cause
A fuse in your home
may be blown or the
circuit breaker tripped.
Power surge.
Plug not fully inserted
into wall outlet.
Door not securely closed. • Open the door and close securely.
The cooktop light is
located below the oven
floor. When the light
is on, the heat it
produces may make the
oven floor get warm.
The control has been
locked.
The vent fan
automatically turns on
to cool internal parts
while the microwave
is on.
The probe has not been
completely inserted into
the oven wall outlet.
The probe is defective.
Probe has been
forgotten or not
inserted properly.
When using a Sensor
feature, the door was
opened before steam
could be detected.
Steam was not detected
in maximum amount
of time.
What to Do
• Replace fuse or reset circuit breaker.
• Unplug the microwave oven, then plug
it back in.
• Make sure the 3-prong plug on the
oven is fully inserted into wall outlet.
• This is normal.
• Press and hold CLEAR/OFF for
about 3 seconds to unlock the control.
• The vent fan cannot be turned off
while the microwave is operating.
This is normal. Wait for the microwave
to turn off and the fan will either go
off automatically or you will need to
turn it off by pressing the Vent Fan
pad after the microwave is off.
• Insert the probe properly into the
oven wall outlet.
• Replace the probe.
• Insert the probe properly into the
oven wall outlet.
• Do not open door until steam is
sensed and time is shown counting
down on display.
• Use Time Cook to heat for more time.