Push Button Configuration - THOMSON TG185n Setup And User Manual

4 The THOMSON TG185n as Wireless Repeater
4.1.1

Push Button Configuration

Procedure
Proceed as follows:
1 Start Push Button Configuration on your access point. For more information, consult the documentation
of your access point.
2 Shortly press the WPS button on your THOMSON TG185n:
3 The WPS button LED starts blinking green.
If the LED does not start to blink, WPS is not enabled on your THOMSON TG185n. For more
information on how to enable WPS, see
4 The WPS button LED will turn solid green when the configuration has been completed. After a few
seconds the LED will turn off again.
E-DOC-CTC-20080624-0009 v2.0
" WPS does not work" on page 51.
23