GE JP938 Technical Service Manual page 11

Electronic Touch Controls
The touch controls provide precise control of the
surface elements. You can quickly switch from a
steady low heat to full power or any setting in
between.
To turn ON a standard surface element, touch the
ON/OFF pad, then touch the (+) or (-) pad. The
surface element will energize to power setting 5.
Use the (+) or (-) pads to choose the desired
setting: L (low), 1-9, or H (high). The control will
beep each time the pad is touched. To turn the
surface element OFF, touch the ON/OFF pad
again.
To turn ON a 9-in. dual surface element, touch the
ON/OFF pad, then touch the (+) or (-) pad. The
small surface element will energize to power
setting 5. Touch the SIZE SELECT pad to energize
both large and small surface elements. Use the (+)
or (-) pads to choose the desired setting. To turn
the large surface element OFF, touch the SIZE
SELECT pad again. To turn both the large and
small surface elements OFF, touch the ON/OFF
pad.
(Some Models,
JP938 & JP968)
– 9 –
To turn ON the bridge element, set the left front
surface element to the desired setting. Touch the
BRIDGE pad. The bridge element will energize to
the same level as the left front surface element
...or, touch the ON/OFF pad for the left front
surface element, then touch the BRIDGE pad.
The left front and bridge elements will both
energize to power setting 5. Using the (+) or (-)
pads will control the setting for both elements. To
turn the bridge element OFF, touch the BRIDGE
pad again. Touching the ON/OFF pad will turn
OFF both the left front and the bridge elements.
To turn ON the warmer surface element, touch
the ON/OFF pad, then touch the WARMER pad.
If the surface element is already in use, touch the
WARMER pad. The surface element will energize
to the warmer power setting W1. Use the (+) or
(-) pads to choose the desired warmer setting:
W1, W2, or W3.
To turn OFF the warmer power setting, touch the
WARMER pad again. The surface element will
remain ON in power setting L (low). To turn OFF
the surface element, touch the ON/OFF pad
again.