GE Max Profile Use And Care Manual page 17

INSTALLATION INSTRUCTIONS
Check to be sure that wiring is not
WARNING
CAUTION
pinched or in contact with the door
springs.
Insert Power Cord Wires
Through Strain Relief
and Tighten.
Ground
Check that Wite, Black and
Green Dishwasher Wires are
Threaded Through Small
Hole in Bracket
Step 14. Pre-test check list
Ñ Check to be sure power is off.
Ñ Open dishwasher door and remove all foam
and cardboard packaging.
Ñ Read the Use & Care manual to familiarize
yourself with the operation of the
dishwasher.
Ñ Add two quarts of water to the bottom of the
dishwasher to lubricate the pump seal.
Ñ Remove the protective film if present from
the control panel and trim.
Ñ Check to be sure that wiring is secure under
the dishwasher. Reattach connections if
necessary.
Ñ Pull lower rack about half way out. Check to
be sure it does not roll back into dishwasher
or further out. If it does, relevel dishwasher.
Ñ Turn on water supply.
Ñ Check for plumbing leaks. Tighten
connections if necessary.
Ñ Turn on the hot water faucet at the sink.
Verify that temperature is at least 120°F.
Adjust the water heater to deliver water
between 120° and 150°F if necessary.
Step 15. Dishwasher wet test check list
Ñ Turn on power supply.
Ñ Latch door.
Ñ Select normal cycle.
Ñ Check to be sure that water enters the
dishwasher. This could take up to 4 minutes.
If water does not enter the dishwasher,
check to be sure that water is turned on.
Ñ Check for leaks under the dishwasher. If a leak
is found, turn off power supply, tighten
connections and restore power.
Ñ Check for leaks around the door. A leak
around the door could be caused by
dishwasher door rubbing or hitting against
adjacent cabinetry. Reposition the dishwasher
if necessary.
Ñ The dishwasher will drain about 5 minutes
after the first fill. Check drain lines. If leaks
are found, turn off power, correct as necessary
and restore power.
White
Black
Let the dishwasher run through another fill
Ñ
and drain cycle. Check again to be sure there
are no leaks.
At the end of the second drain, push the reset
Ñ
pad.
Figure S
Step 16. Replace toekick
Refer to Figure T. Place the toekick against the legs
of the dishwasher. Align the toekick and make sure
the bottom edge is against the floor. Insert and
tighten the two toekick attachment screws, making
sure the bottom edge of the toekick stays in contact
with the floor.
Step 17. Literature
Ñ Be sure to leave complete literature package and
installation instructions with consumer.
Toekick
Adjustment Screws
Figure T
17