Remote Control; How To Use - Panasonic CS-ME7QKUA Operating Instructions Manual

How to use

MODE
To select operation mode
AUTO : During operation mode selection the
POWER indicator blinks.
• Unit selects operation mode every 3 hours
according to setting temperature, outdoor
temperature and room temperature.
HEAT : Unit takes a while to warm up. The
POWER indicator blinks during this operation.
COOL : Use curtains to screen off sunlight
and outdoor heat to reduce power consumption
during COOL mode.
DRY : Unit operates at low fan speed to give
a gentle cooling operation.
POWERFUL
To reach temperature quickly
POWERFUL
• Press the button again or turn OFF the unit to
stop this operation.
QUIET
To enjoy quiet operation
QUIET
• This operation reduces airfl ow noise.
Auto OFF/ON button
6
Use when remote control is a malfunction occurs. Raise the front panel:
1. Press the button once to use in AUTO mode.
2. Press and hold the button until you hear 1 beep, then release to use in forced
COOL mode.
3. Repeat step 2. Press and hold the button until you hear 2 beeps, then release to
use in normal COOL mode.
4. Repeat step 3. Press and hold the button until you hear 3 beeps, then release to
use in forced HEAT mode.
• Press the button again to turn off.
Remote control display
AUTO FAN
SPEED
HEAT
AIR
COOL
SWING
DRY
OFF/ON OFF/ON
MODE FAN SPEED
TEMP TEMP
AIR SWING
QUIET POWERFUL
TIMER TIMER
ON ON SET SET
1 1 2 2 3 3
OFF OFF CANCEL CANCEL
AC RC
SET CHECK CLOCK CHECK RESET
Remote control receiver
and indicator
(Green)
POWER
(Orange)
TIMER
(Orange)
QUIET
(Orange)
POWERFUL
Press and hold for
approximately
10 seconds to show
temperature setting in
°F or °C.
Press and hold for
approximately
5 seconds to show
12-hour (am/pm) or
24-hour time indication.
Press to restore the
remote control to
default setting.
Not used in normal
operations.