00107A SCC-833P/855P - gb 11/22/00 3:36 PM Page 6
Operating Instructions
Connecting Auto Iris Lens Connector
Prepare the Auto Iris Lens Connector, which is
supplied along with the camera.
Rib
Pin3
Pin1
Connect the cable of the control cable, whose
covering is stripped, to the Auto Iris Lens
Connector as shown below.
Pin Number DC Control Type Video Control Type
1
Damp (–)
2
Damp (+)
3
Drive (+)
4
Drive (–)
6
Mounting the Lens
Loosen a screw fixing the Flange Back Adjustment
Ring by turning it counterclockwise and turn the
Adjustment Ring to the "C" direction
(counterclockwise) until it stops. Failure to do so
may result in a damage caused by a bump of the
lens against the image sensor part in the camera
when mounting the lens.
Pin4
Pin2
Power (+9V)
Not used
Video signal
Auto Iris Control Cable
GND
Operating Instructions
C direction
V ID
E O
D C
L E N
S
7