Remove The Access Panel; Install The Access Panel - HP ProLiant BL465c G6 User Manual

Remove the access panel

To remove the component:
Power down the server blade (on page 12).
1.
Remove the server blade (on page 13).
2.
Lift the access panel latch and slide the access panel to the rear.
3.
Remove the access panel.
4.
WARNING:
internal system components to cool before touching them.
CAUTION:
before beginning any installation procedure. Improper grounding can cause ESD.

Install the access panel

Place the access panel on top of the server blade with the hood latch open. Allow the panel to
1.
extend past the rear of the server blade approximately 0.8 cm (0.2 in).
Engage the anchoring pin with the corresponding hole in the latch.
2.
Push down on the hood latch. The access panel slides to a closed position.
3.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, properly ground the server blade
Operations 14