Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
NOTE: This log splitter was partially assembled at the factory. Refer to the drawing and parts list should it become necessary to disassemble the
unit for repair or replacement of parts.
STEP 1: Remove all the components from the crate. Inspect each piece for shipping damage. If any part is damaged, contact your dealer or
delivering carrier.
STEP 2: Attach the tongue (3) to the tank/axle (2) as shown in the diagram using the two 1/2 in. NC x 4-1/2 in. hex cap screws (75), 1/2 in.
lockwashers (77) and 1/2 in. NC hex nuts (76) from the hardware kit. Tighten. NOTE: Flatwashers are included in the hardware kit
should it be necessary to use them as spacers to eliminate play between the tongue and the tank tongue mounting plate.
STEP 3: Remove the rubber covering from the two spindles on the tank/axle (2). The wheel bearing cups, bearing cones, grease seals and hub
caps are already assembled. Bearing cones have been greased at the factory. Remove the hub cap (71) by prying it loose with a
common tip screwdriver. Mount the wheels (63) to the spindles on the tank/axle (2) using the 3/4 in. light flatwasher (68) and 3/4 in.
slotted nut (69) from the hardware kit.Tighten the nut until bearing play is removed and the wheel will still rotate freely. Install the cotter
pin (70) and hub cap (71). Repeat step 4 for the other wheel.
STEP 4: Stand the beam (1) up on end. Make sure that the beam is stable. Remove the pivot pin (73) and the clip pin (74) from the tank/axle (2)
Roll the axle/tongue assembly into position between the two tabs on the beam (1). Slide the pivot pin (73) through the holes and lock in
place with the clip pin (74).
STEP 5: Connect the end of the 1/2 in. I.D. x 47 in. hydraulic hose (14) coming from the fitting (12) on the pump (9) to the fitting (49) on the valve
(5) port marked "IN."
STEP 6: Slide one hose clamp (13) on the end of the 3/4 in. x 44 in. hydraulic hose (20) that comes from the fitting on the tank/axle (2). Then
connect the hose to the fitting (47) on the valve (5). This is the port marked "OUT" on the valve. Tighten hose clamp.
OPERATING INSTRUCTIONS
STEP 1: STARTING
WARNING: Read and thoroughly understand all instructions and safety information before operating
this log splitter. Failure to do so may cause serious injury or death. Do not allow anyone to operate this
log splitter who has not read this manual. As with all power equipment, a log splitter can be dangerous
if assembled or used improperly. Do not operate this log splitter if you have doubts or questions
concerning safe operation. Call our customer service department at 1-800-525-8322 to address these
concerns.
Si no entiende ingles, se prefiere que busque alguien que interprete las instrucciones para usted.
IMPORTANT:
The engine and hydraulic tank are shipped without oil. See the engine operating and maintenance instructions manual packed
with the log splitter for the type of crankcase oil, fuel, etc. The engine manufacturer recommends lead-free gasoline only.
CAUTION:
DO NOT START OR RUN THE ENGINE WITHOUT OIL IN THE HYDRAULIC RESERVOIR AND IN
THE ENGINE.
Page 7
Hide quick links:
Advertisement
Table of Contents
