Table of Contents
Advertisement
TOWING
The log splitter is equipped with pneumatic tires, a Class I coupler (2 in. diameter ball required) and safety chains. Before towing, the safety chains must be
secured to the hitch or bumper of the vehicle. Local regulations should be checked regarding licensing, lights, towing, etc. See also Towing Safety in the
Safety Information section of this manual.
OPERATION
WARNING:
DANGER:
1)
Set up the log splitter in a clear, level area and block the wheels. Make sure that the suction port on the tank is always on the lower side
of the log splitter.
2)
Place a log on the beam against the foot plate. Make sure that the log is securely on the foot plate and up against the beam. Always use
extra care when splitting logs with unsquare ends.
3)
Depress the valve handle so that the cylinder will drive the wedge into the log. Extend the cylinder until the log splits or to the end of its
stroke. If the log has not completely split after the cylinder has reached the end of its extension, retract the cylinder.
IMPORTANT: Leaving the valve in the "actuate" position at the end of the stroke may damage the pump.
NOTE:
For operation in wooded areas, obtain a spark arrestor for the exhaust system. See the engine operating and maintenance manual and
check with your authorized Honda service center. See also Prevent Fire in the Safety Information section of this manual.
NOTE:
Output tonnage varies with altitude.
IMPORTANT:
TO EXTEND THE LIFE OF THE HYDRAULIC CYLINDER, AVOID "BOTTOMING OUT" WEDGE PLATE TO THE FOOT
PIECE. TO CONFORM WITH INDUSTRY SAFETY RECOMMENDATIONS, THE WEDGE STOPS 2 INCHES FROM
THE END OF THE STROKE.
MAINTENANCE
1)
Consult the operating and maintenance instructions of the engine manufacturer for engine care and maintenance.
2)
Always check the oil level of the hydraulic reservoir before operation. Operating the log splitter without an adequate oil supply will
cause severe damage to the pump.
3)
Change the oil filter after the first 25 hours of operation. Thereafter change the oil filter every hundred hours or seasonally, whichever
comes first.
4)
If the wedge becomes dull or nicked, it can be removed and sharpened. Remove the 1/2 in. diameter bolt that connects the wedge to the
cylinder. The hose from the valve may need to be removed. While the log splitter is in the horizontal position, loosen the hose clamp and
disconnect the hose from the valve. Carefully lift the cylinder to alow the wedge to slide forward. The wedge can now be lifted off and
sharpened.
5)
Clean the breather cap after 25 hours of operation. Clean it more often when operated in dusty conditions. To clean, remove the breather
from the tank and flush with kerosene or liquid detergent to remove the dirt.
6)
See also Repair and Maintenance Safety in the Safety Information section of this manual.
7)
All replacement parts must meet manufacturer's specifications.
ALWAYS WEAR SAFETY GLASSES WHEN OPERATING THIS LOG SPLITTER.
KEEP HANDS AND FEET CLEAR OF RAM, STRIPPER PLATES AND BASE PLATE AT ALL TIMES.
Page 9
Hide quick links:
Advertisement
Table of Contents
