Locations And Functions Of Parts - Sony BKS-R3219 Operation Manual

Locations and Functions of Parts

BKS-R3219
1 STATUS button/lamp
Front panel
STATUS
PROT
3 PROT button/lamp
BKS-R1618
1 STATUS button/lamp
Front panel
STATUS
PROT
3 PROT button/lamp
BKS-R3219/R1618
Rear panel
1 STATUSbutton/lamp
The button lights in red when some trouble occurs with
the unit.
When the TALLY display is set to ON, the TALLY
status of the set destination is shown in red or green.
The red tally signal has priority.
2 MONI (monitor) button/lamp
When you press and light the button, the destination
set on the control terminal is monitored, and the source
selected for the destination or the source that the offset
value is added is automatically selected.
For details on setting the monitor, refer to the installation
manual supplied with the routing switcher.
3 PROT (protect) button/lamp
This button has two functions: to set and release
protection for the output connector (destination) and to
indicate whether the currently selected destination is
protected or not.
2 MONI button/lamp
MONI
LOCK
(CHOP)
4 LOCK (CHOP) button/lamp
2 MONI button/lamp
MONI
LOCK
(CHOP)
4 LOCK (CHOP) button/lamp
5 Source/destination select buttons
5 Source/destination select buttons
REMOTE 1
U
RS-232C
-AC IN
9 RS-232C connector
8 REMOTE 1 connector
7 U (ground) connector
6 ~AC IN connector
Protection indication function
When the currently selected destination is protected,
the lamp is lit, and the source select buttons are
disabled. When the protection is set on this unit, the
lamp is lit in green, while it is lit in red when the
protection is set on another unit.
Protection function
When you press this button, the button lights and the
currently selected destination (output) is protected.
When a destination is protected, switching of sources
for the destination is disabled.
To release protection, press the PROT button so that
the lamp goes out.
Note
If the protection has been set to ON AIR mode at the
control terminal, switching is enabled independently
ofthe protection setting. Normally set the protection to
NORMAL mode.
BKS-R3219
BKS-R1618
REMOTE 2
0 REMOTE 2 connector
11