Post Installation Checks; Brick Installation - Lennox Hearth Products Canyon ST310 Installation And Operation Manual

Post Installation Checks

1. Check that all chimney pipe joints are securely fastened.
2. Check that the heater is securely fastened to the floor (if ap-
plicable).
3. Make sure the intake vent has clear access to outside air (if
applicable).
4. Make sure the outside air vent has been sealed properly to
keep rodents out (if applicable).
5. Be sure all roof flashings are watertight.
6. Be sure the stove is properly grounded (if applicable).
FOR YOUR OWN PROTECTION AND INSURANCE PUR-
POSES, HAVE YOUR CHIMNEY AND CONNECTOR PIPE
INSTALLATION INSPECTED BY YOUR LOCAL BUILDING
CODE AUTHORITY OR FIRE MARSHAL BEFORE START-
ING A FIRE IN YOUR STOVE. NOTIFY YOUR INSURANCE
COMPANY.

Brick Installation

CAUTION: Wear gloves during brick installation in case
of sharp edges inside the stove.
Note: Installation of the baffle bricks and insulating blanket is
easier when you can still access the flue outlet, (before connect-
ing the flue pipe). Be sure the insulating blanket is placed flat
on the bricks so as not to block the flue. Use a ruler or a piece of
kindling to reach over the blanket to be sure it is completely flat
on top of the baffle bricks.
Measure bricks before installing, as per list of dimensions on
next page, to be sure the correct bricks are installed in the cor-
rect location.
1. Install bricks #1-34 in the numbered sequence shown in Fig-
ure 6A on the following page. Note: Bricks # 22-25 lean up
against the lower air channel and butt against bricks #17-21
on the bottom of the stove.
Note: Before installing your baffle bricks make sure the stain-
less steel tube support and front and rear tube hangers are
centered side to side and that the front and rear hangers are
hooked onto the stainless steel pins protruding from the rear
of the airwash and the stove back.
2. Next install bricks #35-40 on top of the stainless steel sec-
ondary burn tubes in the upper part of the firebox. These
bricks fit up against bricks #26-30 on the backwall and should
rest on the rear two stainless steel secondary tubes. These
two sets of three bricks go either side of the stainless steel
secondary tube support running front to rear down the center
of the stove.
3. Be sure the stainless steel tube support is in the center, as
shown and that its two stabilizer pieces in the front and the
rear are attached to the two hooks welded to the firebox front
and rear.
4. Included with the stove are two 13" x 17-1/2" x 1" thick ce-
ramic fiber blankets. Install a ceramic fiber blanket on top of
each set of three bricks, making sure the blankets are pushed
fully to the rear.
5. Next, install the front baffle bricks #41-46 under the ceramic
fiber blanket and on top of the front two stainless steel sec-
ondary tubes. (CAUTION: Make sure that the ceramic fiber
blankets are centered side to side and rest flat on the baffle
bricks and do not project forward beyond the front of the
baffle bricks #41-46).
11