Using The Magnify Feature - Hitachi CP-X3030WN Operating Manual

Operating

Using the magnify feature

Press the MAGNIFY ON button on the remote control.
1.
The picture will be magnifi ed, and the MAGNIFY dialog
will appear on the screen. When the MAGNIFY
ON button is pressed for the fi rst time after the
projector is turned on, the picture will be zoomed
by 1.5 times. On the dialog, triangle marks to show
each direction will be displayed.
The display magnifi cation of the projector switches in order with every press
2.
of the MAGNIFY ON button.
For computer signals or HDMI
1.5 times
For video signals, s-video signals, component video signals or
TM
HDMI (Component) signals
1.5 times
While the triangles are displayed on the dialog, use the ▲/▼/◄/► cursor
3.
buttons to shift the magnifying area.
Press the MAGNIFY OFF button on the remote control to exit magnifi cation.
4.
● The MAGNIFY dialog will automatically disappear in several seconds with no
operation. The dialog will appear again if the MAGNIFY ON button is pressed
when the dialog has automatically disappeared.
● The magnifi cation is automatically disabled when the displaying signal or its
display condition is changed.
● While the magnifi cation is active, the keystone distortion condition may vary.
It will be restored when the magnifi cation is disabled.
● Some horizontal stripes might be visible on the image while magnifi cation is
active.
● This function is not available in the following cases:
- A sync signal in the range not supported is input.
- There is no input signal.
30
2 times 3 times
2 times 1 time
TM (RGB) signals
4 times 1 time
MAGNIFY
ON/OFF button
VIDEO COMPUTER MY SOURCE/
DOC.CAMERA
ASPECT AUTO SEARCH BLANK
FREEZE
MAGNIFY PAGE VOLUME
UP
ON
DOWN
OFF
MY BUTTON
KEYSTONE MUTE