Brother HL-1118 User Manual page 47

General Information
LEDs Machine Status
Drum !
The corona wire needs to be cleaned. See Cleaning the corona wire on Improving the print quality.
The Error LED ( ) will blink 3 times and turn off for 1 second.
No Drum
3
If the toner cartridge is placed in the machine without the drum unit, put the toner cartridge into the drum
unit, and then reinstall the drum unit and toner cartridge assembly in the machine.
The Error LED ( ) will blink 3 times and turn off for 1 second.
Jam Tray / Jam Inside 1 / Jam Inside 2 / Jam Inside 3
Clear the paper jam.
See Paper jams on page 54.
If the machine does not start printing, press .
The Error LED ( ) will blink twice and turn off for 1 second.
Wrong Paper Type
The width or length of the paper in the paper tray is too small. Put paper that can be used in the paper
tray, and then press .
Usable paper sizes are A4, Letter, Legal, and Folio. (See Acceptable paper on page 2.)
The Error LED ( ) will blink twice and turn off for 1 second.
No Paper
Put paper in the paper tray you are using.
The Error LED ( ) will blink twice and turn off for 1 second.
Cover is Open
Close the top cover of the machine.
The Error LED ( ) will blink 4 times and turn off for 1 second.
Out of Memory
Press and hold for about 2 seconds until all the LEDs light up and then release it. The machine will
cancel the print job and clear it from the memory.
The machine also cancels the print job and clears it from the memory automatically one minute after
entering the Out of Memory state.
Reduce the complexity of your document or lower the print quality.
The Error LED ( ) will blink 4 times and turn off for 1 second.
Job Cancel
The machine is canceling the job.
The Error LED ( ) and Ready LED ( ) will light up alternately.
40