Basic Multitrack Recording - Creative 202 Owner's Manual

Tutorials

2 - Basic Multitrack Recording

This tutorial assumes you're using a single input or a pair of inputs. For more
advanced recording, refer to the Cubase LE manual.
Add an Audio Track
1. From the Cubase LE menu bar, select Project, Add Track, Audio. An audio
track is added to the project window.
Inspector button
Monitor Track Input
2. The screen shows the "A" input of the 0404 USB. Note that IN 1 is shown in
the Track Input field (Input A =IN1, Input B =IN2). If you want to record in
stereo, turn the Stereo/Mono button On and select IN 1 + IN 2 for the Track
Input.
3. Make sure the Monitor button
through the 0202 USB 2.0.
4. Press the Direct Monitor button on your E-MU 0202 USB 2.0. If you are
recording a mono track, set Direct Monitor to Mono by pressing the Direct
Monitor button again.
Get Ready To Record
5. Plug in your instrument or microphone and set the input gain control for a
good signal level. The green -12 signal LED should come on, but the clip LED
should never come on. You should be hearing your instrument or micro-
phone through your monitor speakers or headphones. If not, go back to steps
4 and 5.
0202 USB 2.0 Owner's Manual
Stereo/Mono button
is OFF. You will be monitoring the input
NOTE
If the Inputs aren't available,
check Devices, VST Inputs.
15