Table of Contents
Advertisement
Input/Output - 0202
NOTE
When using a USB 1.1 port,
performance is limited to
16-bit and 44.1/48 kHz
recording and playback.
E-MU Systems
INPUT/OUTPUT - 0202
USB
R
7
7. USB
Connects the 0202 USB 2.0 to your computer via the supplied USB cable. The
USB connection provides two-way communication when connected to the
computer.
The 0202 USB 2.0 receives its power from the USB. Always connect to the USB
jack on the computer itself and NOT to a low-power USB connection that
may be present on your computer keyboard or other USB peripheral.
8. Main Outputs
The unbalanced outputs are normally connected to your monitoring system.
The signal is duplicated on a stereo 1/8¨ jack for easy connection to desktop
stereo speakers. The outputs are designed using a special noise-cancelling
circuit which reduces problems relating to ground loops.
9. R - Hi Z / Line Input
This 1/4¨ input can be used as a Hi-Z instrument input (guitar/bass, etc.) or a
line level input. The input is balanced, but accepts either balanced or unbal-
anced signals.
10. L - 1/8¨ Mic Input
Connect microphones with 1/8¨ plugs to this jack.
11. L - Hi-Z / Line / Mic Input
Use the XLR connector for microphones or balanced line level signals. Use the
1/4¨ in the center of the XLR jack as a Hi-Z input for guitar/bass, or as a line
level input. The input is balanced, but accepts either balanced or unbalanced
signals.
Ground Lift Switches
There are "ground lift" switches for both analog inputs located on the bottom
of the unit. These switches can be used to safely stop the hum if a ground loop
occurs in your setup. See
Outputs
L
R -
Hi Z / Line
1 Main
8
page 29
for more information.
Inputs
L -
L - Mic
Hi-Z / Line
9
10
11
Mic
10
Advertisement
Table of Contents
