Andset Ound Ignals; Roubleshooting Guide - GE 21018 User Manual

H S
ANDSET OUND
Signal
A long warbling tone (with ringer on)
Three short beeps
One short beep (every 7 seconds)
T
ROUBLESHOOTING
T S
ELEPHONE OLUTIONS
No dial tone
• Check or repeat installation steps:
Make sure the base power cord is connected to a working
electrical outlet.
Make sure the telephone line cord is connected to the base and the
wall jack.
• Connect another phone to the same jack. If it doesn't work, the problem
might be your wiring or local service.
• The handset may be out of range of the base. Move closer to the base
• Make sure the battery is properly charged (for 16 hours).
• Make sure the battery pack (in the handset) is properly installed.
• The handset should beep when you press the TALK/END/CALLBACK
button, and the charge indicator on the base should be lit when the
handset rests in the cradle. If not, the battery may need to be charged.
• Place handset in charge cradle for at least 20 seconds to reset the unit.
Handset does not ring
• Make sure the handset ringer software switch is set to on.
• The handset may be out of range of the base. Move closer to the base.
S
IGNALS
G
UIDE
Meaning
Signals an incoming call
Page signal
Low battery warning
37