Reset Sensors - Bosch Security System User Manual

RESET SENSORS ?

Reset Sensors
Description
Detection devices, such as smoke detectors and shock sensors,
must be reset after being activated. This function momentarily
removes power from these sensors to reset them. It also clears
point information from the display, leaving the ALARM
SILENCED message in the display as a reminder that the View
Memory function can be used to view the cleared point
information. Entering a valid passcode and then pressing the ESC
key clears the ALARM SILENCED message and the event
memory. Arming the system also clears the display and the event
memory.
Using Reset Sensors:
1. Ensure that your keypad is at idle disarmed text.
2. Press the COMMAND bar. The display shows SYSTEM
COMMAND.
3. Press the 4 key followed by the 7 key.
Note: If you prefer, you might use the Command Menu in place
of steps 2 and 3 to initiate this function. Press the MENU
key to enter the Command Menu, then press NEXT
repeatedly until you reach the RESET SENSORS ?
prompt. Press ENT.
4. The display shows SENSORS RESETING for
approximately 3 seconds and then goes blank before
returning to idle disarmed text.
If you enter this function and the detector or sensor resets
momentarily, but then returns to a faulted condition, the
conditions causing the activation might still be present or the
detector might be faulty. Check to be certain that there is no smoke,
fire, or other danger present.
If you can't reset the detector or sensor contact your security
company.
47