Bosch Security System User Manual page 36

WALK TEST ? continued
4. The burglary bell sounds for 2 seconds. When the display
panel shows ## PTS TO TEST you can begin. Test each
point by first opening and then closing the door or
window. Check the display after testing each point. For
interior points, walking past the device once is sufficient.
If any point does not test correctly, contact your security
company for service.
5. During the Walk Test you might want to see the points
that remain untested. When point text is displayed, press
ESC. The display shows ## PTS TO TEST. Press the ESC
key. VIEW UNTESTED ? is displayed. Press ENT. The
display shows ## PTS UNTESTED. Press NEXT to see a
list of the points that are untested. Move through this list
by pressing the NEXT key. To resume the Walk Test, press
ESC. # PTS UNTESTED is displayed. Press ESC. ## PTS
TO TEST is displayed. Resume testing points. To end the
Walk Test, press ESC twice.
6. When all points are tested, 0 PTS TO TEST is displayed.
Press ESC. The display momentarily shows ALL PTS
TESTED before returning to idle text.