1. Prepare the Installation Site
■
Cabling Infrastructure - To ensure proper operation when
installing the switch into a network, make sure that the current
cables are suitable for 10Base-T, 100Base-TX, or 1000Base-T
operation.
Be sure to follow the guidelines below to ensure proper operation
when installing the switch into a network:
•
Cable type: Unshielded twisted pair (UTP) or shielded
twisted pair (STP) cables with RJ-45 connectors, maximum
length 100 meters (328 ft); Category 3 or better for 10Base-T,
Category 5 or better for 100Base-TX, and Category 5, 5e, or 6
for 1000Base-T.
•
Protection from radio frequency interference emissions.
•
Use electrical surge suppression.
•
Use safe connections with no damaged cables, connectors or
shields.
Installation Location - Before installing the switch, plan its
■
location and orientation relative to other devices and equipment.
At the front of the switch, leave at least 7.6 cm (3 inches) of space
for the twisted-pair cabling. At the back of the switch, leave at least
2.6 cm (1 inch) of space for the adapter's power cord.
Installing the Switch
Installation Procedures
2-5